How to inspect, clean and store 3M™ Reusable Respirators

Inspection

• Respirator must be inspected before each use; repair or dispose of it if damaged or defective

• Check the faceseal for cracks, tears and dirt

• Examine the inhalation valves for distortion, cracking or tearing

•Check that the headstraps are intact and have good elasticity

• Examine all plastic parts and gaskets for cracking and fatigue

• Examine exhalation valve for cracks, tear, distortion, etc; replace valve if necessary

• Check lens for signs of cracking or damage; replace if necessary

Do not enter a contaminated area while wearing a damaged or defective respirator.

Cleaning and storage

Cleaning is recommended after each use.

• Remove cartridges, filters and/or breathing tubes

• Remove centre adapter, lens and faceseal, if necessary

• Clean facepiece by immersing it in warm cleaning solution

• Scrub with a soft bristle brush until clean

• Water temperature must not exceed 49º C (120º F)

• Disinfect facepiece by soaking in a solution of quaternary ammonia disinfectant, sodium hypochloride or household bleach

• Rinse in fresh, warm water and air dry in a non-contaminated atmosphere

• Place clean, dry respirator in a clean bag and store away from the contaminated area when not in use

• 3M™ Respirator Cleaning Wipes can be used for interim cleaning but must not be the only cleaning method in place

Download.

Previous Article
Choosing lens tint
Choosing lens tint

How to pick the right tinted safety glasses for your job to protect your eyes properly.

Next Article
How to select the right cartridges or filters for your 3M™ Reusable Respirator
How to select the right cartridges or filters for your 3M™ Reusable Respirator

Did you know that there are different kinds of cartridges for different kinds of gases and vapours? 3MTM Ga...